Sharpening when developing or in the print module?

  • Thread starter Thread starter chichornio
  • Start date Start date
Status
Not open for further replies.
C

chichornio

Guest
I´m been playing around with the NR silders in the Detail section of the Develop Module and it´s really great. LR 3 Beta 2 does a very good job in NR if you keep you file with the less sharpening settings (the file looks a little soft, but with no artifacts really visible at 1''% crop). Anyone have tried when it`s better to sharp the picture when you want to print that file? In the Developing stage or in the final print output section? Any help welcome.
Guillermo, from Argentina
 
Sort by date Sort by votes
Hi Guillermo

Best idea is to sharpen the image in Develop to get good capture sharpness from the raw data, and then select the correct paper type for sharpening when printing. It's based on Bruse Fraser's multi-pass sharpening, if you fancy googling to find out a bit more.
 
Upvote 0 Downvote
Status
Not open for further replies.
Back
Top