Image Info in Loupe View

[MMarz]

Not sure what I've done, and I've done it before..

I have the View Options, when in Loupe View set to Display Info 1 at the change of an image, but also have Info 2 set and use "I" shortcut to cycle as needed..

For some reason both the preview of Info 1, as well as the function of using the "I" shortcut seem to stop working. No rhyme or reason as far as I can tell.. I set all the parameters while in the Loupe View, close the View Options dialog box, the Info 1 doesn't display and the "I" shortcut doesn't work.. Go back to the View Options dialog and it is again incomplete.. so it's not saving the View Options when in Loupe View...

Are there any prerequisites to using the "I" key or for having the preview of Info 1 displayed? What might I have done to suppress the use of the "I" shortcut or "Ctrl I"??

It seems to work fine in the Develop Module, but not in Loupe View

 

[wkibbler]

Michael

I find that Loupe Info turns itself off from time to time. This is quite prevalent when I output to Photomatix or Photoshop. No rhyme or reason why but I have to tell it to display again, however in the Loupe menu it is checked and should be displayed.

Wayne